Lancer L4-2.4L SOHC (2005)
YES: Go to Step 16.
NO: Replace the fog light indicator light bulb. Verify that the fog light indicator light illuminates normally.
STEP 16. Check the ground circuit to the fog light indicator light. Measure the resistance at combination meter connector C-02.
1. Disconnect fog light indicator light connector C-02 and measure the resistance available at the wiring harness side of the connector.
2. Measure the resistance value between terminal 48 and ground.
-
The resistance should equal 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?
YES: Go to Step 18.
NO: Go to Step 17.
STEP 17. Check the wiring harness between combination meter connector C-02 (terminal 48) and ground.
Q: Is the wiring harness between combination meter connector C-02 (terminal 48) and ground in good condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the fog light indicator light illuminates normally.