Lancer L4-2.4L SOHC (2005)
STEP 29. Check the wiring harness between side turn-signal light (RH) connector A-01 (terminal 2) and ETACS-ECU connector C-226
(terminal 9).
NOTE: Also check junction block connector C-210 and intermediate connector C-111 for loose, corroded, or damaged terminals, or terminals pushed
back in the connector. If junction block connector C-210 or intermediate connector C-111 are damaged, repair or replace the damaged component(s) as
described in Harness Connector Inspection.
Q: Is the wiring harness between side turn-signal light (RH) connector A-01 (terminal 2) and ETACS-ECU connector C-226 (terminal 9) in good
condition?
YES: Replace the socket. Verify that the turn-signal lights illuminate normally.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the turn-signal lights illuminate normally.
STEP 30. Check rear combination light (LH) connector F-14 for loose, corroded or damaged terminals, or terminals pushed back in the
connector.
Q: Is rear combination light (LH) connector F-14 in good condition?
YES: Go to Step 31.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the turn-signal lights illuminate normally.
STEP 31. Check the rear turn-signal light bulb (LH).
1. Remove the rear turn-signal (LH) light bulb.
2. Verify that the rear turn-signal light bulb (LH) is not damaged or burned out.
Q: Is the rear turn-signal (LH) light bulb in good condition?
YES: Go to Step 32.
NO: Replace the rear turn-signal (LH) light bulb. Verify that the turn-signal lights illuminate normally.
STEP 32. Check the ground circuit to the rear turn-signal light (LH). Measure the resistance at rear combination light (LH) connector F-14.
