Lancer L4-2.4L SOHC (2005)
1. Disconnect rear combination light (LH) connector F-14 and measure the resistance available at the wiring harness side of the connector.
2. Measure the resistance value between terminal 5 and ground.
-
The resistance should equal 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?
YES: Go to Step 34.
NO: Go to Step 33.
STEP 33. Check the wiring harness between rear combination light (LH) connector F-14 (terminal 5) and ground.
Q: Is the wiring harness between rear combination light (LH) connector F-14 (terminal 5) and ground in good condition?
YES: Replace the socket assembly. Verify that the turn-signal lights illuminate normally.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the turn-signal lights illuminate normally.
