Lancer L4-2.4L SOHC (2005)
4. Erase the diagnostic trouble codes and, after waiting five seconds or more, read (and write down) all displayed diagnostic trouble codes.
REPAIR PROCEDURE
WHEN FRONT AIR BAGS DEPLOY IN A COLLISION.
1. Replace the following parts with new ones.
-
SRS-ECU.
-
Air bag module.
-
Seat belt with pre-tensioner.
2. Check the following parts and replace if there are any malfunctions.
-
Clock spring.
-
Steering wheel, steering column and shaft assembly
1. Check the wiring harness (built into the steering wheel) and connectors for damage, and terminals for deformation.
2. Install the air bag module to check fit or alignment with the steering wheel.
3. Check the steering wheel for noise, binds or difficult operation and excessive free play.
4. Check the collision energy absorbing mechanism on the steering column shaft. (Refer to On-vehicle Service Steering Column Shaft
Assembly Shock Absorbing Mechanism Check).
3. Check the wiring harnesses for binding, the connectors for damage, poor connections, and the terminals for deformation.
WHEN SIDE-AIRBAGS DEPLOY IN A COLLISION
1. Replace the following parts with new ones.
-
SRS-ECU.
-
Side impact sensors.
-
Front seatback assembly (Refer to Front Seat).
2. Check the wiring harnesses for binding, the connectors for damage, poor connections, and the terminals for deformation.
WHEN AIR BAGS DO NOT DEPLOY IN LOW-SPEED COLLISION.
Check the SRS components. If the SRS components are showing any visible damage such as dents, cracks, or deformation, replace them with new ones.
Concerning parts removed for inspection, replacement with new parts and cautionary points for working, refer to appropriate INDIVIDUAL
COMPONENT SERVICE.
SRS-ECU
1. Check the SRS-ECU case and brackets for dents, cracks or deformation.
2. Check the connector for damage, and the terminals for deformation.
3. Check the fit of the SRS-ECU and its bracket.
AIR BAG MODULES
