Lancer Evolution L4-2.0L DOHC Turbo (2003)
Q:
Is ETACS-ECU connector C-226 in good condition?
YES: Go to Step 2.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. The system should communicate with the ETACS-ECU
normally.
STEP 2.
Check the battery power supply circuit to the ETACS-ECU. Measure the voltage at ETACS-ECU connector C-226.
1. Disconnect ETACS-ECU connector C-226 and measure the voltage available at the junction block side of the connector.
2. Measure the voltage between terminal 20 and ground.
-
The voltage should equal approximately 12 volts (battery positive voltage).
Q:
Is the measured voltage approximately 12 volts (battery positive voltage)?
YES: Go to Step 4.
NO: Go to Step 3.
STEP 3.
Check the wiring harness between ETACS-ECU connector C-226 (terminal 20) and the battery.