Lancer Evolution L4-2.0L DOHC Turbo (2003)
CAUTION: When inserting the fuel pump module or fuel pipe and gauge assembly into the fuel tank, be careful not damage the sensor unit and
the float.
5. Install the fuel pump module or fuel pipe and gauge assembly. Tighten the mounting nuts to the specified torque.
Tightening torque: 2.5 ± 0.5 Nm (23 ± 4 in-lb)
CAUTION: Snap the fuel high-pressure hose one-touch joint into place, then pull back slightly on the hose to assure it is secure. However, the
connection should have a play of approximately 3.0 mm (0.12 inch).
6. Connect the harness connector, fuel high-pressure hose, suction hose and fuel return hose.
7. Replace the service hole cover.
8. Install the rear seat cushion assembly. (Refer to Rear Seat Assembly).