Lancer Evolution L4-2.0L Turbo (4B11T/C) (2010)
/Page-989003.png)
If the rear brake disk removal is difficult, install bolts (M8 x 1.25 mm) shown in the figure, and tighten them evenly and gradually to remove the rear
brake disk.
Installation Service Points
PARKING BRAKE LINING AND DRUM
INSTALLATION SERVICE POINTS
[A] WASHER INSTALLATION
Install the washer in the direction shown in the illustration.
[B] CHAMBER RETAINER INSTALLATION
Use pliers or a similar tool to close the chamber retainer end onto the pin.
[C] ADJUSTER ASSEMBLY INSTALLATION
