Lancer Evolution L4-2.0L Turbo (4B11T/C) (2010)
3. Measure the voltage between joint connector (CAN1) terminal 7 and body ground.
OK: 4.7 V or less
4. Measure the voltage between joint connector (CAN1) terminal 20 and body ground.
OK: 4.7 V or less
Q: Do all the voltages measure 4.7 V or less?
YES : Go to Step 17.
NO : Go to Step 50.
STEP 17. Check the wiring harness between joint connector (CAN1) C-105 and SRS-ECU connector C-37 for a short to power supply.
Measure the voltage at joint connector (CAN1) C-105.
1. Disconnect joint connector (CAN1), and measure the voltage at the wiring harness side of joint connector (CAN1).
2. Turn the ignition switch to the ON position.
3. Measure the voltage between joint connector (CAN1) terminal 8 and body ground.
OK: 4.7 V or less