Lancer Evolution L4-2.0L Turbo (4B11T/C) (2010)
Control Arm: Service and Repair
Rear Suspension
Control Link and Lower Arm
CONTROL LINK AND LOWER ARM
REMOVAL AND INSTALLATION
CAUTION
^
Do not damage the control link ball joint dust cover and the trailing arm ball joint dust cover during maintenance. If they are damaged,
replace the control link ball joint dust cover and trailing arm ball joint dust cover.
^
The part indicated by *1 should be temporarily tightened, and then fully tightened with the vehicle standing on the ground at the curb
weight condition.
^
The parts indicated by *2 are the nuts with friction coefficient stabilizer. In removal, ensure there is no damage, clean dust and soiling
from the bearing and thread surfaces, and tighten them to the specified torque.
Post-installation Operation
Removal Steps 1-6
Required Special Tool: