Lancer Evolution L4-2.0L Turbo (4B11T/C) (2010)
^
MB991897 or MB992011: Ball Joint Remover
REMOVAL SERVICE POINTS
[A] SELF-LOCKING NUT REMOVAL
CAUTION
^
Loosen the self-locking nut from the ball joint, but do not remove here. Use the special tool.
^
To prevent the special tool from dropping off, suspend it with a cord.
1. Install special tool MB991897 or MB992011 as shown in the figure.
2. Turn the bolt and knob to make the special tool jaws parallel, then hand-tighten the bolt. After tightening, check that the jaws are still parallel.
NOTE: To adjust the special tool jaws to be parallel, set the orientation of the knob as shown in the figure.
3. Tighten the bolt with a wrench to disconnect the ball joint connection.
[B] CONTROL LINK ASSEMBLY/LOWER ARM ASSEMBLY REMOVAL
Make mating marks on the adjusting bolts, and remove the control link assembly and lower arm assembly.
INSTALLATION SERVICE POINT
[A] SELF-LOCKING NUT INSTALLATION