Lancer Evolution L4-2.0L Turbo (4B11T/C) (2010)
Before disposal of the strut, place the strut on the level surface with the piston rod extended, and make a hole of approximately 3 mm in diameter at
the point shown in the figure to discharge the gas.
ASSEMBLY SERVICE POINTS
[A] COIL SPRING INSTALLATION
Install the coil spring to align the bottom with the shape of the strut spring seat.
[B] UPPER SPRING SEAT INSTALLATION
Align the D-shaped hole with the D (cut-oft) of the strut, and install the marked part shown in the figure facing the inside of the vehicle.
[C] STRUT NUT (JAM NUT) INSTALLATION
1. Check that both of the coil spring ends align with the spring seat groove correctly.