Lancer Sportback L4-2.4L (4B12) (2010)
/Page-572051.png)
3. Measure the voltage between joint connector (CAN3) terminal 4 and body ground.
OK: 4.7 volts or less
4. Measure the voltage between joint connector (CAN3) terminal 15 and body ground.
OK: 4.7 volts or less
Q: Do all the voltages measure 4.7 volts or less?
YES : Check intermediate connector C-128, and repair if necessary. If the intermediate connector is in good condition, repair the wiring harness
between joint connector (CAN2) C-05 and joint connector (CAN3) C-124.
NO : Go to Step 16.
STEP 7. Check the wiring harness between joint connector (CAN3) C-124 and shift lever connector C-49 for a short to power supply. Measure
the voltage at joint connector (CAN3) C-124.
1. Disconnect joint connector (CAN3), and measure the voltage at the wiring harness side of joint connector (CAN3).
2. Turn the ignition switch to the ON position.
3. Measure the voltage between joint connector (CAN3) terminal 7 and body ground.
OK: 4.7 volts or less