Mirage L4-1597cc 1.6L DOHC (1990)
CAUTION: When replacing, replace the synchronizer hub and sleeve as a set.
SYNCHRONIZER KEY AND SPRING
-
Check for wear of the synchronizer key center protrusion.
-
Check the spring for weakness, deformation and breakage.
SPEED GEARS
-
Check the bevel gear and clutch gear teeth for damage and wear.
-
Check the synchronizer cone for rough surface, damage and wear.
-
Check the gear bore and front and rear ends for damage and wear.
SERVICE POINTS OF REASSEMBLY
16. INSTALLATION OF TAPER ROLLER BEARING - F5M22
Install the taper roller bearing over the intermediate shaft using the special tool as illustrated.
CAUTION: When installing the bearing, push the inner race only.
15. INSTALLATION OF BALL BEARING - F5M21