Mirage L4-1597cc 1.6L DOHC (1990)
Install the bail bearing over the intermediate shaft using the special tool as illustrated.
12. 7.
INSTALLATION OF SYNCHRONIZER RINGS
The 1st-2nd speed synchronizer rings have an identification mark.
11. INSTALLATION OF 1ST-2ND SPEED SYNCHRONIZER HUB / 10. SYNCHRONIZER KEY / 9. 1ST-2ND SPEED SYNCHRONIZER
SLEEVE / 8. SYNCHRONIZER SPRING
1. Combine the 1st-2nd speed synchronizer hub and sleeve as illustrated.
2. Assemble the synchronizer spring so that its protrusion may be engaged in the groove of the synchronizer key.
NOTE: Take care to prevent the protrusions of the front and rear spring from sitting in the groove of the same key.