Montero Sport 2WD V6-3.0L SOHC (1997)
1. Using special tool MB990201, temporarily tighten the side bearing nut to just before preloading of the side bearing.
2. Measure the drive gear backlash.
Standard value:
<4G64> 0.08 - 0.13 mm (0.003 - 0.005 inch)
<6G72> 0.13 - 0.18 mm (0.005 - 0.007 inch)
3. Using special tool MB990201, adjust the backlash to standard value by moving the side bearing nut as shown.
NOTE: First loosen the side bearing nut then tighten the side bearing nut the same amount as when it was loosened.
4. Using special tool MB990201, to apply the preload, turn down both right and left side bearing nuts on half the distance between centers of
two neighboring holes.
