Montero Sport LS 2WD V6-3.0L SOHC (1998)
Disconnect the negative (-) battery cable from the battery and tape the terminal to prevent accidental connection and deployment.
2. Remove Front Impact Sensor.
Pre-installation Inspection
To mount the new front impact sensor, visually check it and measure the resistance between the terminals.
Installation
To install reverse the removal steps and note the following.
2. Front Impact Sensor Installation
WARNING: The SRS may not activate properly if a front impact sensor is not installed properly, which could result in serious injury or
death to the vehicle's driver.
1. Securely connect the connector.
2. Position the front impact sensor facing toward the front of the vehicle as shown by the arrow on the label, and install it securely.
Post-installation Inspection
1. Reconnect the negative (-) battery cable.
2. Turn the ignition key to the "ON" position.
3. Does the "SRS" warning light illuminate for approximately seven seconds, and then remain off for at least five seconds after turning OFF?"
4. If yes, the SRS system is functioning properly.
Sensor Cable Installation
