Montero Sport LS 2WD V6-3.0L SOHC (1998)
If there is a malfunction in the front wiring harness between the front impact sensor and body wiring harness, install and route a new sensor cable.
WARNING: Wait at least 60 seconds after disconnecting the battery cable before doing any further work.
1. Disconnect the negative (-) battery cable and tape the terminal to prevent accidental connection and air bag(s) deployment.
2. Make a cut in the grommet in the place shown in the illustration, and pass the sensor cable through the cut.
3. Run the sensor cable along the front wiring harness, and then secure the cable to the harness with insulation tape.