Montero Sport LTD 4WD V6-3.5L SOHC (1999)
a.
Begin by inserting the moulding into the slot at the rear area of the side step.
b.
For straight alignment, use the lip at the top of the side step moulding attaching surface as a guide.
5.
Using a clean cloth, apply firm pressure along the length of the moulding to ensure proper adhesion.
PARTS INFORMATION
WARRANTY INFORMATION
Technical Service Bulletin # 99-42A-006
Date: 990201
Side Step (Running Board) Molding - Wrinkles
NO: TSB-99-42A-006
DATE: February, 1999
MODEL: 1999 Montero Sport
SUBJECT:
WRINKLES IN SIDE STEP MOULDING
PURPOSE
Some vehicles may have wrinkle-type marks in the side step moulding which were caused by the moulding being bent during factory installation. This
condition has been corrected in production since 12/3/98.
The side step moulding must be removed and replaced. This bulletin contains specific instructions for removing the moulding adhesive and installing the
new moulding.
AFFECTED VEHICLES
1999 Montero Sport Limited models equipped with 3.5L engine produced before 12/3/98 only
PROCEDURE
