Montero Sport XLS 4WD V6-3.0L SOHC (1999)
WARNING: Support special tool MB991113 or MB990635 with a cord, etc. to prevent it from coming off.
Use special tools MB991113 or MB990635 to disconnect the lower arm ball joint form the knuckle.
NOTE: Only loosen the mounting nut, do not remove it from the ball joint
Installation Service Points
>A< Torsion Bar/Rear Anchor Arm Installation
1. Check the identification marks at the end of the left and right torsion bars.
R for right side
L for left side
2. When installing the torsion bar, align the white mark on the serrated section of the torsion bar with the mating mark on the anchor arm.
3. Mount the anchor bolt as shown in the illustration, and install the rear anchor arm adjusting nut.
>B< Bump Stopper And Bump Stopper Bracket Clearance Adjustment
