Montero Sport XLS 4WD V6-3.0L SOHC (1999)
1. With the vehicle in an unladen condition, dimension A from the bump stopper to the bump stopper bracket should be 18 mm (0.7 inch).
NOTE: Dimension A will be (B = 50 mm [2.0 inches]) when the bump stopper is a new part. When the bump stopper is worn and becomes
less than 50 mm (2. 0 inches), dimension A will increase by the decreased amount.
2. If dimension A is not 18 mm (0.7 inch), adjust the anchor arm assembly adjusting nut.
INSPECTION
Lower Arm Ball Joint End Play
Check the lower arm ball joint assembly end play by following the steps below.
1. Measure the lower arm ball joint assembly end play with a dial indicator.
Limit: 0.3 mm (0.01 inch)
2. If the lower arm ball joint assembly end play exceeds the limit, replace the lower arm ball joint assembly.
Lower Arm Ball Joint Dust Cover Check
1. Press the dust cover with a finger to check whether the dust cover is cracked or damaged.
2. When dust cover is cracked or damaged, replace the lower arm ball joint assembly.
NOTE: If the dust cover is cracked, the ball joint could be damaged, so if the dust cover is damaged during maintenance work, replace it.
Rear Lower Arm Bushing Replacement
1. Using the special tool M13991522, remove the lower arm bushing (A) from the bracket.
NOTE: When removing the left hand rear lower arm bushing, detach the differential carrier. (Refer to Differential carrier.)