Montero Sport XLS 4WD V6-3.0L SOHC (1999)
2. Using the special tool M13991522, press-fit the lower arm bushing (A) into the bracket.
NOTE: Install the rear lower arm bushing in the direction shown in the illustration.
Front Lower Arm Bushing Replacement
1. Remove the front lower arm bushing from the lower arm by using special tools M13990883, M13990971.
2. Coat the front lower arm bushing and the lower arm with soap solution and press-fit the front lower arm bushing into the lower arm by using
special tools MB990883 and MB990971 and taking care not to twist or tilt the front lower arm bushing.
NOTE: Press-fit the front lower arm bushing again from the opposite side to equalize bushing projections at both ends.
Lower Arm Ball Joint Dust Cover Replacement
Only when dust cover is damaged accidentally during service work, replace the dust cover as follows:
1. Apply multipurpose grease to the interior of the dust cover and the lower arm ball joint.
2. Secure the dust cover to the lower arm ball joint with ring.
