Montero SR 4WD V6-3.5L SOHC (1997)
A. Snap ring removal. (2)
B. Second brake piston removal. (7)
1. With the second brake piston held, blow air into the second brake drum through the oil hole to remove the second brake piston.
CAUTION: Do not blow air suddenly because the piston may be tipped and become hard to remove.
INSPECTION
Return Spring Assembly
1. Measure the free length of the spring including the spring seat.
Standard value: Approximately 15.05 mm (0.5925 inch)
ASSEMBLY
Assembly in reverse order as Disassembly.
NOTE: Assembly service points as follows:
A. Snap ring installation. (2)
CAUTION: Be sure the end gap of the snap ring is not aligned with the stopper of the spring seat.
One-Way Clutch, A/T