Montero XLS 4WD V6-3.5L SOHC (2001)
>>B<< AIR MIX DAMPER LEVER CABLE INSTALLATION
1. Set the temperature control knob on the heater control assembly to the maximum hot position.
2. Set the air mix damper lever of the heater/cooler unit to the maximum hot position as shown in the illustration, and then connect the cable to the
lever pin.
3. Push the outer cable in the direction of the arrow so that there is no looseness, and then secure it with the clip.
Disassembly and Assembly
Disassembly and Assembly
DISASSEMBLY SERVICE POINT
<<A>> AIR OUTLET CHANGEOVER DAMPER LEVER CABLE AND AIR MIX DAMPER LEVER CABLE ASSEMBLY
Insert a flat-tipped screwdriver into the control base clip from inner side, and then remove the cable by lifting the claw part of the clip.