Montero XLS 4WD V6-3.5L SOHC (2001)
Required Special Tools:
-
MB991223: Test Harness Set
-
MB991502: Scan Tool (MUT-II)
-
MB991529: Diagnostic Trouble Code Check Harness
STEP 1. Check the rear wiper operation.
Q: Does the rear wiper motor work (However, the rear wiper does not stop at the predetermined park position.)?
YES: Go to Step 2.
NO: Check the rear wiper motor drive circuit. Refer to Inspection Procedure H-1.
STEP 2. Check the rear wiper motor.
1. Disconnect the rear wiper motor connector I-07.
2. Run the rear wiper motor, disconnect the battery, and stop the motor.
3. Reconnect the battery as shown in the illustration, and confirm that after the motor starts turning it stops at the automatic stop position.
Q: Is the rear wiper motor in good condition?
YES: Go to Step 3.
NO: Replace the rear wiper motor. The rear wiper motor auto-stop signal should be able to be checked and the rear wiper should stop at the
predetermined park position.
STEP 3. Check the rear wiper motor power supply circuit at the wiper motor connector I-07 by backprobing.
1. Do not disconnect the rear wiper motor connector I-07.
2. Turn the ignition switch to "ACC" position.
3. Measure the voltage between terminal 4 and ground by backup robing.
Q: Is the voltage approximately 12 volts (battery positive voltage)?
