Montero XLS 4WD V6-3.5L SOHC (2001)
YES: Go to Step 6.
NO: Go to Step 4.
STEP 4. Check rear wiper motor connector I-07 for damage.
Q: Is rear wiper motor connector 1-07 in good condition?
YES: Go to Step 5.
NO: Repair or replace it. Refer to Harness Connector Inspection. The rear wiper motor auto-stop signal should be able to be checked and the rear
wiper should stop at the predetermined park position.
STEP 5. Check the harness wires between rear wiper motor connector I-07 and ignition switch (ACC).
NOTE: After checking intermediate connectors G-10 and D-111 and junction block connectors D-217 and D-208, check the wires. If intermediate
connectors G-10 and D-111 and junction block connectors D-217 and D-208 are damaged, repair or replace them. Refer to Harness Connector
Inspection.
Q: Are the harness wires between rear wiper motor connector I-07 and ignition switch (ACC) in good condition?