Montero XLS 4WD V6-3.5L SOHC (2001)
2. Measure the resistance between terminal 6 and ground.
Q: Is the resistance less than 2 ohm?
YES: Go to Step 30.
NO: Go to Step 28.
STEP 28. Check back door lock actuator switch connector I-05 for damage.
Q: Is back door lock actuator switch connector I-05 in good condition?
YES: Go to Step 29.
NO: Repair or replace it. Refer to Harness Connector Inspection. The input signal from the back door lock actuator switch should be able to be
checked and the functions, which are described in the "Technical Description (comment)," should work normally.
STEP 29. Check the harness wire between back door lock actuator switch connector I-05 and ground.
Q: Is the harness wire between back door lock actuator switch connector I-05 and ground in good condition?
YES: There is no action to be taken.
NO: Repair them. The input signal from the back door lock actuator switch should be able to be checked and the functions, which are described in the
"Technical Description (comment)," should work normally.
