Outlander 2WD V6-3.0L (6B31) (2007)
Pay attention to fastener locations. There are 4 (four) different types of push-pin retaining clips and one bolt (10 mm head) used for the splash shield.
Fasteners MUST be installed in their original location.
Torqued the bolt as indicated when installing the new splash shield.
PARTS INFORMATION
Use the Genuine Mitsubishi Parts listed.
WARRANTY INFORMATION
This bulletin is supplied as technical information only and is not an authorization to repair. If an affected vehicle is observed with the described condition
diagnose the condition repair as described in this bulletin and submit a normal warranty claim using the following information.
SPLASH SHIELD REPLACEMENT
Nature Code: 56T
Cause Code: 160
Labor Operation No.: 42202595
Time Allowance: 0.5 hr.
Warranty Coverage: Basic coverage.
Technical Service Bulletin # 09-42A-012
Date: 090908
Body - Front Inner Fender Liner Damaged
No: TSB-09-42A-012
DATE: September, 2009
MODEL: 2007-09 Outlander
SUBJECT:
FRONT INNER FENDER LINER (SPLASH SHIELD)
DAMAGED
PURPOSE
The front inner fender liner (splash shield) may deform due to wind pressure when driving at high speed during hot weather. Suspension travel may allow
a tire to contact and damage the deformed shield.
NOTE:
The left splash shield of vehicles equipped with V6 engines is damaged most often.
This TSB provides instructions to replace deformed and damaged front inner fender liners with reinforced parts listed in the Parts Information section of