Outlander 2WD V6-3.0L (6B31) (2007)
1. Disconnect joint connector (CAN1), and measure the voltage at the wiring harness side of joint connector (CAN1).
2. Turn the ignition switch to the ON position.
3. Measure the voltage between joint connector (CAN1) terminal 10 and body ground.
OK: 4.7 volts or less
4. Measure the voltage between joint connector (CAN1) terminal 23 and body ground.
OK: 4.7 volts or less
Q: Do all the voltages measure 4.7 volts or less?
YES(vehicles without satellite radio): Go to Step 23.
YES(vehicles with satellite radio): Go to Step 22.
NO: Go to Step 32.
STEP 22. Check the wiring harness between joint connector (CAN1) C-103 and satellite radio tuner connector C-111 for a short to power
supply. Measure the voltage at joint connector (CAN1) C-103.
CAUTION: A digital multimeter should be used.
CAUTION: The test wiring harness should be used.
1. Disconnect joint connector (CAN1), and measure the voltage at the wiring harness side of joint connector (CAN1).
2. Turn the ignition switch to the ON position.