Outlander AWD L4-2.4L (4B12) (2010)
/Page-632031.png)
NO: Repair or replace the damaged component(s). Check that the input signal of hood switch is normal.
STEP 2.Check the hood switch.
Remove the hood switch. Then check continuity between the switch terminals.
Q: Is the hood switch in good condition?
YES: Go to Step 3.
NO: Replace the hood switch. Check that the input signal of hood switch is normal.
STEP 3. Check the ground circuit to the hood switch. Test at hood switch connector A-06.
1. Disconnect hood switch connector A-06 and measure the resistance available at the wiring harness side of the connector.
2. Measure the resistance value between terminal 2 and ground.
-
The resistance should equal 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?
YES: Go to Step 5.
NO: Go to Step 4.
STEP 4. Check the wiring harness between hood switch connector A-06 (terminal 1) and ground.
Check the ground wires for open circuit.
Q: Is the wiring harness between hood switch connector A-06 (terminal 1) and the ground in good condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Check that the input signal of hood switch is normal.
STEP 5. Check ETACS-ECU connector C-312 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is ETACS-ECU connector C-312 in good condition?
YES: Go to Step 6.
NO: Repair or replace the damaged component(s). Check that the input signal of hood switch is normal.
STEP 6. Check the wiring harness between driver's door switch connector A-06 (terminal 2) and ETACS-ECU connector C-312 (terminal 12).
