Outlander AWD L4-2.4L (4B12) (2010)
Check the input lines for open circuit and short circuit.
Q: Is the wiring harness between driver's door switch connector A-06 (terminal 2) and ETACS-ECU connector C-312 (terminal 12) in good
condition?
YES: Replace the ETACS-ECU. Check that the input signal of hood switch is normal.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Check that the input signal of hood switch is normal.
ETACS-ECU Does Not Receive Any Signal From the Liftgate Switch
Inspection Procedure 11: ETACS-ECU does not receive any signal from the liftgate switch.
Liftgate Switch Input Circuit
TECHNICAL DESCRIPTION (COMMENT)
If there is an error to the liftgate switch input signal, the liftgate switch signal is no longer output to the communication line.
TROUBLESHOOTING HINTS
-
The liftgate switch may be defective
-
The ETACS-ECU may be defective
-
The wiring harness or connectors may have loose, corroded, or damaged terminals, or terminals pushed back in the connector