Outlander AWD L4-2.4L (4B12) (2010)
-
Remove the ignition key from the ignition key cylinder.
-
Open the driver's door.
Q: Does scan tool MB991958 display the items "Dr door unlock", "Dr door ajar switch", and "Handle lock switch" as normal condition?
YES [Normal conditions are displayed for all the items.] : Go to Step 3.
NO [Normal condition is not displayed for item No. 228.] : Troubleshoot the ETACS-ECU. Refer to Diagnosis - Inspection Procedure 4
"ETACS-ECU does not receive any signal from the front door lock actuator". See: Body and Frame/Body Control Systems/Body Control
Module/Testing and Inspection/Scan Tool Testing and Procedures/Input Signal Procedures/Inspection Procedure 4
NO [Normal condition is not displayed for item No. 254.] : Troubleshoot the ETACS-ECU. Refer to Diagnosis - Inspection Procedure 2
"ETACS-ECU does not receive any signal from the ignition switch (IG1)". See: Body and Frame/Body Control Systems/Body Control
Module/Testing and Inspection/Scan Tool Testing and Procedures/Input Signal Procedures/Inspection Procedure 2
NO [Normal condition is not displayed for item No. 256.] : Troubleshoot the ETACS-ECU. Refer to Diagnosis - Inspection Procedure 6
"ETACS-ECU does not receive any signal from the front the front door switch (RH)". See: Body and Frame/Body Control Systems/Body Control
Module/Testing and Inspection/Scan Tool Testing and Procedures/Input Signal Procedures/Inspection Procedure 6
NO [Normal condition is not displayed for item No. 264.] : Troubleshoot the ETACS-ECU. Refer to Diagnosis - Inspection Procedure 3
"ETACS-ECU does not receive any signal from key reminder switch". See: Body and Frame/Body Control Systems/Body Control
Module/Testing and Inspection/Scan Tool Testing and Procedures/Input Signal Procedures/Inspection Procedure 3
NO [Normal condition is not displayed for item No. 270, 271.] : Troubleshoot the ETACS-ECU. Refer to Diagnosis - Inspection Procedure 4
"ETACS-ECU does not receive any signal from front door lock actuator". See: Body and Frame/Body Control Systems/Body Control
Module/Testing and Inspection/Scan Tool Testing and Procedures/Input Signal Procedures/Inspection Procedure 4
STEP 3.Check key reminder switch connector C-211, ETACS-ECU connector C-315 for loose, corroded or damaged terminals, or terminals
pushed back in the connector.
Q: Is key reminder switch connector C-211, ETACS-ECU connector C-315 in good condition?
YES : Go to Step 4.
NO : Repair the damaged parts.
STEP 4.Check the Wiring harness between key reminder switch connector C-211 (terminal No. 5) and ETACS-ECU connector C-315 (terminal
No. 18).
-
Check the input/output line for open circuit.
Q: Is the check result normal?
YES : Go to Step 5.
NO : Repair the wiring harness between key reminder switch connector C-211 and ETACS-ECU connector C-315.
STEP 5.Check of ignition key cylinder illumination light bulb.
Q: Is the ignition key cylinder illumination light bulb in good condition?