Outlander AWD L4-2.4L (4B12) (2010)
Use special tool MB990767 to fix the hub and remove the driveshaft nut.
[B] CALIPER ASSEMBLY REMOVAL
1. Remove the caliper assembly with brake hose.
2. Secure the removed caliper assembly with a wire or other similar material at a position where it will not interfere with the removal and installation
of the rear wheel hub assembly.
[C] REAR WHEEL HUB ASSEMBLY REMOVAL
1. If the rear wheel hub assembly is seized with the rear driveshaft assembly, use special tools MB990242 and MB990244, MB991354 and
MB990767 to push the rear driveshaft assembly out from the hub and then remove the rear wheel hub assembly.
2. If the rear wheel hub assembly is seized with the knuckle, use special tools MB990211 and MB990241 {combination (A)}, or MB990211 and
MB991354 {combination (B)} to remove the rear wheel hub assembly.
INSTALLATION SERVICE POINTS