Outlander AWD L4-2.4L SOHC (2003)
4. Remove the connection between the C-09 air bag module (front passenger's side) connector (two-pin, red) and the harness side connector (two-pin,
red).
NOTE: If the C-09 air bag module connector is disconnected, both electrodes of the air bag module connector will be automatically shorted to prevent
unintended deployment of the air bag due to static electricity, etc.
5. Connect deployment wires, each 6 meters (20 feet) or longer, to the two leads of special tool MB686560, and cover the connections with
insulation tape. The other ends of the deployment wires should be connected to each other (short-circuited), to prevent sudden unexpected
deployment of the air bag module.
6. Connect the C-09 air bag module (front passenger's side) connector (two-pin, red) to special tool MB686560 and move the deployment wires out
of the vehicle.
WARNING: If the glass is scratched, air bag deployment could cause it to crack and fly out of the vehicle, so always put a cover over the
vehicle.
7. To suppress the operation sound as much as possible completely close all door windows, close the doors and put the cover on the vehicle.
WARNING: Before deploying the air bag in this manner, first check to be sure that there is no one in or near the vehicle. Wear safety glasses.
The inflator will be quite hot immediately following the deployment, so wait at least 30 minutes to allow it to cool before
