Outlander AWD L4-2.4L SOHC (2003)
CAUTION: Do not tap the journal bearings to remove them, as this will upset the balance of the propeller shaft.
1. Use Special Tool MB990840 to press in the journal bearing on one side, and take out the journal bearing on the opposite side.
2. Insert special tool MB990840 into the other side and press the journal to remove the first journal bearing that was pushed.
<<C>> CENTER YOKE REMOVAL
Make mating marks on the center yoke and center propeller shaft, and then remove the center yoke.
<<D>> CENTER BEARING ASSEMBLY/BOLT REMOVAL
1. Make mating marks on the rear propeller shaft, DOJ assembly and companion flange, and then remove the bolt.
2. Use the special tool MD998801 to remove the center bearing assembly from the center propeller shaft.
<<E>> DOJ ASSEMBLY REMOVAL