Outlander AWD L4-2.4L SOHC (2003)
1. Remove the DOJ boot from the DOJ assembly.
2. Make mating marks on the outer race, cage and inner race, and then remove the circlip, outer race and ball.
NOTE: Note the positions of the balls so that they can be reinstalled in their original positions.
3. Remove the inner race with cage from the center propeller shaft assembly by using a puller (commercially available).
4. Wipe off the grease and clean the outer race, inner race, cage and balls.
<<F>> DOJ BOOT REMOVAL
When the DOJ boot is reused, tape the spline part on the rear propeller shaft and then remove the DOJ boot.
ASSEMBLY SERVICE POINTS
>>A<< DOJ BOOT INSTALLATION
1. Install the boot band.
2. Wrap a plastic tape around the spline part on the rear propeller shaft and then install the DOJ boot.
>>B<< DOJ ASSEMBLY INSTALLATION
1. Apply a thin coat of the specified grease to the ball grooves of the inner and outer races.
Specified grease: Repair kit grease
2. Assemble the DOJ assembly as follows:
1) Assemble the outer race, cage, balls, and inner race with their mating marks aligned.
2) Install the circlip.
