PRECAUTIONS AND PREPARATION - Nissan 180SX S13 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 180SX Nissan 180SX S13 1989 Workshop Manual
- Section
- General › PRECAUTIONS AND PREPARATION - Nissan 180SX S13 Workshop Manual
PRECAUTIONS AND PREPARATION
PRECAUTIONS AND PREPARATION
Precautions @ When installing each rubber part, final tightening must be carried out under unladen condition*® with tires on ground. * Fuel, radiator coolant and engine oil full. Spare tire, jack, hand tools, and mats in designated positions. So @ Use Tool when removing or installing brake tubes. S: @® When removing each suspension part, check wheel align- ment and adjust if necessary. GG94310000 Do not jack up at the lower arm. @ SBRS500 Preparation
SPECIAL SERVICE TOOLS
*: Special tool or commercial equivalent Tool number Pp
Description
Tool name
HT71780000* Removing and installing coil spring Spring compressor
Fixing strut assembly $T35652000* Strut attachment
Removing and installing brake piping GG94310000* Flare nut torque wrench
Removing inner race of wheel bearing $T30031000* Bearing puller
Removing and installing bushing
, $T38280000 of rear axle housing Arm bushing remover
RA-2
Parts & tools for this job For Nissan 180SX
- PARTRear wheel bearingSearch: Nissan 180SX rear wheel bearing
- TOOLBearing puller kitSearch: wheel bearing puller kit
- PARTCV boot kitSearch: Nissan 180SX cv boot kit
As an Amazon Associate we earn from qualifying purchases.