Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual22 · RA rear axle & suspension
22 · Steering & suspension

PRELIMINARY INSPECTION - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › PRELIMINARY INSPECTION - Nissan 180SX S13 Workshop Manual
RA rear axle & suspensionPRELIMINARY INSPECTION - Nissan 180SX S13 Workshop Manual

PRELIMINARY INSPECTION

CHECK AND ADJUSTMENT — On-vehicle

Rear Wheel Bearing @ Check tightening torque of wheel bearing lock nut. ©}: 235 - 314 Nem (24 - 32 kg-m, 174 - 231 ft-lb) @ Check that wheel bearings operates smoothly. @ Check axial end play. Axial end play:

0.05 mm (0.0020 in) or less q If axial end play is not within specification or wheel bearing { does not turn smoothly, replace wheel bearing assembly. SRAI7A Refer to REAR AXLE — Wheel Hub and Axle Housing. Rear Wheel Alignment Radial runout Before checking rear wheel alignment, be sure to make a preliminary inspection.

PRELIMINARY INSPECTION

Lateral runout Make following checks. Adjust, repair or replace if necessary, @ Check tires for wear and for improper inflation. @ Check rear wheel bearings for looseness. @ Check wheel runout. Refer to $.D.S. @ Check that rear shock absorber works properly. SFA5755 @ Check rear axle and rear suspension parts for looseness. @ Check vehicle posture (Unladen). “Uniaden’”’: Fuel tank, radiator and engine oil full. Spare tire, jack, hand tools and mats in designated positions.

CAMBER @ Measure camber of both right and left wheels with a sultable allgnment gauge and adjust In accordance with the following procedures.

SRADSBA Camber: -1°40' to -0°40'

‘io SRA0gTA

RA-6

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.