Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual24 · ST steering
24 · Steering & suspension

ON-VEHICLE INSPECTION - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › ON-VEHICLE INSPECTION - Nissan 180SX S13 Workshop Manual
ST steeringON-VEHICLE INSPECTION - Nissan 180SX S13 Workshop Manual

ON-VEHICLE INSPECTION

ON-VEHICLE INSPECTION

Checking Steering Wheel Play

@

With wheels in a straight-ahead position, check steering

wheel play. Steering wheel play: 35 mm (1.38 in) or less @ If it is not within specification, check rack and pinion assembly.

5871038

Checking Neutral Position on Steering Wheel

O.K. N.G. Pre-checking @ Verify that the steering gear is centered before removing the steering wheel. / Checking \ S3) @ Check that the steering wheel is in the neutral position when driving straight ahead. NN oe @ If it is not in the neutral position, remove the steering wheel and reinstall it correctly. @ if the neutral position is between two serrated teeth, loosen tie-rod lock nut and move tie-rod in the opposite direction SST104B by the same amount on both left and right sides to compensate for error in the neutral position.

Front Whee! Turning Angle

@ Rotate steering wheel all the way right and left: measure turning angle. Turning angle of full turns: Refer to section FA for S.D.S.

SMA127 @ if it is not within specification, check rack stroke. Measured length “L’’: Refer to §.D.S. EF et

SSTO86B

ST-5

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.