ON-VEHICLE INSPECTION - Nissan 180SX S13 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 180SX Nissan 180SX S13 1989 Workshop Manual
- Section
- General › ON-VEHICLE INSPECTION - Nissan 180SX S13 Workshop Manual
ON-VEHICLE INSPECTION
ON-VEHICLE INSPECTION
Checking Gear Housing Movement @ Check the movement of steering gear housing during stationary steering. The maximum allowable movement is as follows: Movement of gear housing: +2 mm (+0.08 in) (on dry paved surface) or less Apply a force of 49 N (5 kg, 11 Ib) to steering wheel to check the gear housing movement. On models equipped with power steering, turn off ignition key while checking. — SST105B @ If movement exceeds the limit, replace mount insulator after confirming proper installation of gear housing clamps.
Adjusting Rack Retainer
AN Sy
\y @ Perform this driving test on a flat road. [PN
ZENG I 1. Check whether vehicle moves in a straight line when
a Uy, <
steering wheel is released.
aN
2. Check whether steering wheel returns to neutral position when steering wheel is released from a slightly turned (ap- prox. 20°) position. . @ If any abnormality is found, correct it by resetting adjusting screw. 58ST 1068
ST-6
Parts & tools for this job For Nissan 180SX
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Nissan power steering fluid
As an Amazon Associate we earn from qualifying purchases.