BF - Body: BODY ALIGNMENT - Nissan 200SX S12 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 200SX Nissan 200SX S12 1986 Workshop Manual
- Section
- General › BF - Body: BODY ALIGNMENT - Nissan 200SX S12 Workshop Manual
BF - Body: BODY ALIGNMENT
BODY ALIGNMENT
All dimensions indicatea in figures are actual ones. © When a tram tracking gauge is used, adjust both pointers to equal length and check the pointers and gauge itself to make sure there is no free play. When a measuring tape is used, check to be sure there is no elangation, twisting or bending. ¢ Measurements should be taken at the center of the mounting holes. An asterisk {*) following the value at the measuring point indicates that the measuring point on the other side is symmetrically the same value, Measurement points ‘© ‘The coordinates of the measurement points are the distances measured from the respective dimension and "2", lines in the directions of “x Dimension lines: “x” line — Center line of vehicle — Center line of front axle (Any measurement point in front of the dimen: e refers to.a minus “—" value.) Datum line (Any measurement point under the dimension line refers toa
MEASUREMENT 120.9 025)
1496.2 (68.91)"
04 Unit: sort
BF-42
Parts & tools for this job For Nissan 200SX
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Nissan power steering fluid
As an Amazon Associate we earn from qualifying purchases.