Workshop Manuals Factory service & repair Nissan and Datsun
01 Nissan-S110 S12 S13 S14 S15 Silvia 200SX 240SX02 INDEX03 GI - General Information04 MA - Maintenance05 EM - Engine Mechanical06 LC - Engine Lubrication & Cooling07 EF&EC - Fuel & Emission Control08 FE - Engine Control, Fuel & Exaust09 CL - Clutch10 MT - Manual Transmission11 AT - Automatic Transmission12 PD - Propeller Shaft & Differential13 FA - Front Axle & Suspension14 RA - Rear Axle & Suspension15 BR - Brake System16 ST - Steering System17 BF - Body18 HA - Heater & Air Conditioner19 EL - Electrical System20 Inch/Metric Converion Tables21 Quick Reference Chart
Nissan and Datsun Nissan 200SX S12 1986 Workshop Manual17 · BF - Body
17 · Body & interior

TRIM AND MOLDING - Nissan 200SX S12 Workshop Manual

Make
Nissan and Datsun
Model
200SX Nissan 200SX S12 1986 Workshop Manual
Section
General › TRIM AND MOLDING - Nissan 200SX S12 Workshop Manual
BF - BodyTRIM AND MOLDING - Nissan 200SX S12 Workshop Manual

TRIM AND MOLDING

TRIM AND MOLDING

Weatherstrip and Exterior (Cont'd)

+ Remove it only if itis necessary to do so.

2. Raise and of molding and, while cutting off », Removal: bonding agent, detach molding.

1. Heat molding portion to 30 to 40°C (86 to © Installation.

OSB eis Dest a

1, Remove all traces of bonding agent from body

panel. Then clean contact face of body.

2. Heat body panel and molding to 30 to 40°C (86 to 104°F) with a heat gun. Then instal molding.

S0FA55A

ruber

\

e-teced cdesive 08 J | ee, °

Jr combination lore:

= £ ep Resa pane! finisher ail Butyl rubber ‘Sealing rubber Rear apcon upper saFoe1c

BF-27

Parts & tools for this job For Nissan 200SX

As an Amazon Associate we earn from qualifying purchases.