AUTOMATIC RESTRAINT SYSTEM (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › AUTOMATIC RESTRAINT SYSTEM (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual
AUTOMATIC RESTRAINT SYSTEM (Cont'd)
ELECTRICAL 20-30
AUTOMATIC RESTRAINT SYSTEM (Cont'd)
SYMPTOM: Warning lamp does not flash when ignition switch is “ON”. | ) | wz [| Control Unit Connector CARR Does warning lamp flash if terminal (2) DISCONNECT is grounded? \ [Ne a * Check harness. Replace control unit. » Check bulb. SYMPTOM: Warning chime does not operate for 6 seconds after ignition e) switch is ON, when releasing belt from buckle. | 6 DISCONNECT | } Control Unit Connector Check continuity between terminal (6) and ground. [ne * Check harness. * Check shoulder belt buckle. V.
1. Continuity should not exist when Do other warning chimes such both front seat belts are fastened. as light warning chime operate?
2. Continuity should exist when either the driver’s or the passenger's front [Ns seat belt is unfastened. * Go to “TIME CONTROL SYSTEM” in EL section of vehicle Service Manual.
Check harness between terminal @) and chime.
Parts & tools for this job For Nissan 240SX
- TOOLOBD2 scanner with SRSSearch: OBD2 scanner ABS SRS
- TOOLTrim removal tool kitSearch: trim removal tool kit
As an Amazon Associate we earn from qualifying purchases.