AUTOMATIC RESTRAINT SYSTEM - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › AUTOMATIC RESTRAINT SYSTEM - Nissan 240SX 1991-1992 Workshop Manual
AUTOMATIC RESTRAINT SYSTEM
20-29 ELECTRICAL
AUTOMATIC RESTRAINT SYSTEM
ELECTRICAL DIAGNOSTIC PROCEDURES
Preparation for Trouble Diagnoses
1. Remove floor center console (see vehicle Service Manual).
2. Disconnect harness automatic restraint controller connector.
Power Supply Circuit Check Terminals Ignition Switch @ 3) OFF or ACC ON O 3|2 @ Ground OV 12V Control Unit @) Ground 12V 12V Connector
Ground Circuit Check Control Unit Terminals Continuity Connector @) Ground Yes (e) DISCONNECT ima [2
Trouble Diagnoses SYMPTOM:
@ > FOR LH.
DISCONNECT i Warning lamp flashes continuously. @) : FOR RH. 244 + 5 as Does continuity exist between terminal (4) and ground or terminal Control Unit Connector (S) and ground? Net “| Yes [No Repair harness. Does door latch switch signal (battery voltage) exist between
terminal (0 and ground or terminal i
and ground?
Control Unit Weg Connector : FOR LH. DISCONNECT ie) Yes [No -FOR R.H } 11 [10] Replace door lock assembly. Replace control unit.
DOOR CLOSE = 0V
DOOR OPEN = 12V
Parts & tools for this job For Nissan 240SX
- TOOLOBD2 scanner with SRSSearch: OBD2 scanner ABS SRS
- TOOLTrim removal tool kitSearch: trim removal tool kit
As an Amazon Associate we earn from qualifying purchases.