Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual22 · No. 4 Bow
22 · General

No. 4 Bow - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › No. 4 Bow - Nissan 240SX 1991-1992 Workshop Manual
No. 4 BowNo. 4 Bow - Nissan 240SX 1991-1992 Workshop Manual

No. 4 Bow

NO. 4 BOW 17-3

NO. 4 BOW

REMOVE

NOTE: To help prevent damage, tape a protective cover to the belt moldings, deck lid, quarter panels and both sides of backtlite.

1. REMOVE HEADLINER ASSEMBLY (see 10-3).

2. REMOVE TOP COVER FROM NO. 1 BOW (see 11-3).

3.

REMOVE TOP COVER FROM 2 AND 3 BOWS.

Remove three (3) screws each from bows and top cover retainers.

4.

REMOVE TOP COVER FROM RIGHT AND LEFT SEAL

CARRIERS. Carefully break cement bond by pulling top cover material from seal carrier groove.

5.

REMOVE TOP COVER FROM NO. 4 BOW.

(a) Fold top cover side material over No. 4 bow. (b) Slide stay pad tack strip down for retainer removal clearance.

(c) Pull top cover No. 4 bow inner retainer from top cover retainer.

(d) Remove top cover No. 4 bow retainer from No. 4 bow groove. (e) Fold top cover assembly rearward onto trunk lid.

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.