Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual22 · No. 4 Bow
22 · General

No. 4 Bow - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › No. 4 Bow - Nissan 240SX 1991-1992 Workshop Manual
No. 4 BowNo. 4 Bow - Nissan 240SX 1991-1992 Workshop Manual

No. 4 Bow

17-4

NO. 4 BOW

NO. 4 BOW (cont’d)

6.

REMOVE STAY PADS FROM NO. 4 BOW.

(a) Using an awl, remove staples securing side and backlite stay pads to No. 4 bow. (bo) Repeat step (a) on other side of vehicle.

7.

REMOVE NO. 4 BOW ASSEMBLY.

(a) Remove two (2) screws from each slat and pull No. 4 bow from slats.

(6) Mark center of backlite to No. 4 bow and remove screw. (c) Rotate bow and slide from backlite assembly removing bow from vehicle.

8.

REMOVE NO. 4 BOW SLATS.

(b) Remove two (2) bolts and four (4) bushings securing bow slats to rear rail assemblies.

INSTALL

1.

INSTALL NO. 4 BOW SLATS.

(a) Position No. 4 bow slats to rear rails. (b) Apply Loctite (P/N 271 or equivalent) to bolt threads and install two (2) bolts and four (4) bushings. Torque: 17 Nm (13 ft. Ib.)

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.