Windshield Header Molding - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › Windshield Header Molding - Nissan 240SX 1991-1992 Workshop Manual
Windshield Header Molding
WINDSHIELD HEADER MOLDING
2-4
HEADER MOLDING CAP (cont'd) Apply a continuous bead of weatherstrip adhesive (3M P/N (b) 051135-08008 or equivalent) to weatherstrip retainer.
NOTE: Insure weatherstrip adhesive fills void at center of weatherstrip mounting surface.
Position weatherstrip to top of "A" pillar and secure with (c) retainer (push pin).
Install weatherstrip starting at center of "A" pillar then (d) working upward to top of "A" pillar. Repeat steps 1 and 2 for other side of vehicle. (e)
NOTE: Do not “stretch” weatherstrip so as to create a bulge at top of “A” pillar
WINDSHIELD HEADER MOLDING
REMOVE REMOVE RIGHT AND LEFT HEADER MOLDING CAPS (see
1. Header Molding Cap in this chapter). REMOVE WINDSHIELD HEADER GARNISH MOLDING (see 1-
2. 3)
REMOVE WINDSHIELD HEADER MOLDING.
3. Remove seven (7) nuts and header molding from vehicle.
NOTE: If header molding is to be replaced, transfer mounting studs to new molding.
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.