Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual07 · Windshield Header Molding
07 · General

Windshield Header Molding - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Windshield Header Molding - Nissan 240SX 1991-1992 Workshop Manual
Windshield Header MoldingWindshield Header Molding - Nissan 240SX 1991-1992 Workshop Manual

Windshield Header Molding

WINDSHIELD HEADER MOLDING

2-5

WINDSHIELD HEADER MOLDING (cont'd)

INSTALL

1.

INSTALL WINDSHIELD HEADER MOLDING.

(a) Position molding retainer studs to holes in windshield header. (b) Install seven (7) nuts to molding retainer studs. Do not tighten nuts at this time.

2. INSTALL WINDSHIELD HEADER MOLDING CAPS (see Header Molding Cap in this chapter).

3.

SECURE WINDSHIELD HEADER MOLDING TO HEADER.

While maintaining header molding alignment to header molding caps, tighten seven (7) molding nuts. Torque: 1.5 Nm (13 in. Ib.)

5. INSTALL WINDSHIELD HEADER GARNISH MOLDINGS (see 1-4).

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.