405 L4-1905cc 1.9L (1989)
-
Remove the speaker and door panel
-
Remove the existing speaker housing gasket (A1) and replace with a new type seal (A2) supplied under P/N 9391.W5 (see figure 3)
-
Ensure that the speaker wire retaining clip (b) protrudes through the insulating sheet and that the sheet is firmly pressed against tbe inner door
skin
-
Reinstall the door panel
-
Check to make sure that the door panel is fully seated against the door by clip (c) (see fig 4)
-
If necessary, install a new clip (P/N 6992.51)
-
On 1989 and 1990 models only, apply a sealer (such as T-3 Silicone Sealer, 3M P/N 08660, or equivalent) to the holes at (b) (see figure 4)
-
Reinstall the speaker and ensure that the wiring (d) loops down at (e) (see figure 5)
-
Repeat for the other side if necessary
Important:
A revision to the inner door skin on front doors supplied under P/N 9004.A6 and 9004.A8 has made the installation of the new speaker door seal (P/N
9391.W5) mandatory during front door replacement.
NOTE:
These new front doors have been installed in production on 405 vehicles built as of VIN 0521014.
Also, during installation of a new insulating sheet (P/N 9365.23 and 9365.24), punch a hole through the sheet at the point where the speaker wiring