405 L4-1905cc 1.9L (1989)
CHECKING-PROCEDURE:
-
This check is to be performed from the driver's seat position
-
Open glove box lid
-
Close the glove box lid with your hand placed on the release latch lever
-
Repeat open/close motion, three times, each time applying varying amounts of effort
-
If the glove box lid latches at least once during this test, the car should be considered acceptable
-
If the glove box lid does not latch after 3 attempts, proceed as follows:
-
Close glove box lid by pulling it up at point (A) (from passenger seat)
-
Remove right front kick/rocker panel assembly
-
Loosen dashboard right side mounting screw (B)
-
Pull or push the lower right part of dashboard until you obtain an acceptable alignment
-
Tighten the dashboard screw (B) in this position
-
Repeat checking procedure
-
Install right front kick/rocker panel assembly
CAUTION: Ensure that wires are not pinched upon installation of the kick/rocker panel assembly