405 L4-1905cc 1.9L (1989)
-
Install the extraction tool (2) over the bushing if it is still intact
-
Carefully mark the tool's position on the housing (3)
NOTE:
The bushing's alignment in the motor mount is critical; therefore, be sure that the pins (4) on the extraction tool (2) engage the bushing as shown
-
Press out the old bushing; be sure the press arbor is properly positioned on the extraction tool to avoid cocking the bushing in it's bore
-
In the event that it was not possible to mark the housing prior to removal of the bushing, position the mount behind the abutment sleeve (1) and mark
as shown at (3)
INSTALLATION:
-
Position the abutment sleeve (1) on the press table with the small diameter opening facing up
-
Place the blower motor mount on the sleeve as shown
-
Install the extraction/installation tool (2) onto the bushing, being sure that the pins engage the bushing as previously shown
-
Line up the index mark of the installation tool (2) with the mark (3) previously made in the motor mount
